
Honda CBR1000RR-R /SP (2024+) Velocity Stack Kit
The
perfect modification for your Honda CBR1000RR-R engine. 3D
printed from lightweight composite, the BT Moto Velocity Stacks have
been carefully engineered and designed to maximize power in the higher
RPM range while not losing power in the low RPM range.
Made
for a perfect fit, the BT Moto velocity stacks have a relief notches at
the bottom of each funnel to ensure tight fitment while also being easy
to install. These are plug and play and require no additional
modifications to your airbox to fit. Simply unscrew your factory
velocity stacks and screw ours in. Coupled with our engineered flash,
the combination makes an extremely easy install and tune that can be
done in your own garage.
DYNO
Graph (Stage 2 With And Without Aftermarket Velocity Stacks):Below
is our Stage 2 flash with a exhaust system with and without aftermarket
velocity stacks. You can see little to no loss in the mid and low-range
RPM. Up top you can see a significant gain. All on pump gas 93. Same
day testing on the same bike.
BT MOTO STAGE 1, 93 Pump Gas: 192whp / 81wtq
BT MOTO STAGE 2, 93 Pump Gas + Velocity Stacks: 201whp / 82wtq
BT MOTO STAGE 2, 93 Pump Gas + Velocity Stacks: 201whp / 82wtq
BT MOTO STAGE 2, MR12 Race Fuel + Velocity Stacks: 213whp / 90wtq
STOCK EURO CBR, Pump Gas: RED
BT MOTO STAGE 2, Pump Gas: BLUE
**All
in-house testing performed with 93 octane pump gas, unless otherwise
stipulated. Different modifications and dynometers may make different
power. Usage of a lower octane will yield smaller power gains. All power
is measured from the wheel and not the crankshaft, whp (wheel
horsepower) and wtq (wheel torque)**
RESOURCES / DOWNLOADS
DOCUMENTS
Device Reset FAQ and How-To PDF
BT Moto Handheld Instructions
BT Moto Flasher+ Troubleshooting Guide
VIDEOS How To Install Handheld Tuner
How To Install BT Moto RSV4 Velocity Stacks