Overview
AEM
FACTORY parts are all designed and made in Italy to the highest
standards. Made with great attention to detail to achieve the best
functionality and weight loss on every part, and of course great looks.
This is THE tool you’ll need to tighten AEM's 12 Point (bi-hex) rear wheel nuts. Billet machined from the same alloy they use for their nuts, these sockets are meant to be heavy duty and are hard anodized.
For large hub equipped Ducati bikes -Will fit our nuts with the integrated slider too and MV Agusta models.
We always recommend:
1- do NOT USE PNEUMATIC GUNS, impulses can damage the anodized finish
2- use a good quality manual CALIBRATED TORQUE WRENCH with 12mm (1/2″) drive
3- the good old “tape trick”, use a layer of tape around the nuts for extra care to avoid scratches while tightening/loosening
