Overview
IMPORTANT NOTE: Top Mount and Bottom Mount refer to how the caliper hangs, and therefore if the logo is readable - bottom mount caliper hangs UNDER the bike
MOTO GP QUALITY, WITHOUT THE MOTO GP COST!!!
Beringer's AEROTEC Radial calipers Offer Race Level Performance, Weight savings, and Strength / Durability, while allowing you the freedom to order a system that is specifically engineered to meet your demands. Each Half is machined from a block of Billet aluminum - the same aluminum Beringer uses to make the Aircraft and Race car Brakes its Famous for! Meticulously Designed & Machined with FEM software to optimize the weight/strength ratio, Beringer are always straight bolt on, Coated in in your choice of 12 Finishes and then assembled with only the Highest Quality Hardware. Pistons are 27mm in Diameter and you can swap them for the option
Titanium Ones with embedded magnets that Pull your pads from the rotor
just a little bit more than they would normally (see related items
below)
2 piston billet rear caliper with 84mm bolt spacing. Straight replacement for the Italian-made cast caliper found on many Italian machines. Fluid inlet and bleeder can be inverted to obtain the shortest brake line possible. Beringer logo can be engraved for mounting below or above the swing arm. Pictured in 2D1-R-TM (Red, top mount) 2D1-G-BM (Gold, bottom mount). Titanium Pistons with Magnets are available for Drag and Landspeed Racing. See part number TiMagP27
Pads included are Sintered, Road pads, good for casual to aggressive riding and occasional track days. Racing pads are available Below.
Will these Fit my bike? For most European, bikes, Yes. For all others you will need to supply a mounting bracket
Colors:
